Motor sensor wires-How do I extend them?

This is where you may discuss Electric Skateboard Belt-Drive BLDC Outrunner Motors.
Post Reply
Glider
Posts: 9
Joined: Thu Aug 03, 2017 7:09 am

Motor sensor wires-How do I extend them?

Post by Glider » Thu Aug 03, 2017 7:29 am

My motors wires wont reach my speed controllers...

What is the recommended method to extend them?

I cannot move the esc any closer to the motor.

No, I wont just chop them off!

I am prepared to cut the wires an inch or two back from the connector and use similar gauge copper stranded wire to extend them, is there anything wrong with this method?
(sensor interference/sensitivity etc)

Thank you e-skate builders!

Post Reply